KB Article: Fingerprint enrollment on F22

How to enrol fingerprints on a ZKTeco F22 device

The easiest way to enroll fingerprint templates, is to make use of an enrollment reader (Refer to our product page) together with the Binary City Time Enrollment application. However, it is also possible to enroll directly on a F22 device.

The instructions below will guide you on how to do this enrollment process.

For the enrollment of users on the F22 device, the staff member (employee) must first be loaded in Binary City Time.

Ensure that the staff member is loaded on Binary City Time and synced to the device first (never enroll a new user on the device without creating the person in Binary City Time first).

For instructions on how to load a new employee in Binary City Time, please refer to the section in our manual, by clicking here.

Step 1. Create the employee in Binary City Time.

Step 2. On the F22 device, press and hold the M/OK button to access the Menu.

If an administrator, has already been linked to the device, it will indicate: “Please verify”, which means that general staff members cannot open the menu of the device. A registered “device administrator” needs to then open the menu with his or her registered fingerprint (or pin code, or RFID card).

Step 3. Once you in the Menu screen, navigate using the up and down arrows on the device to get to User Management (User Mgt), and press M/OK on the device to continue.

Step 4. Once you are in User Mgt, navigate using the up and sown arrows on the device to gt to 'All Users' and press the M/OK button to continue.

Step 5. Using the up and down arrows, scroll to the employee you wish to enroll and press the M/OK button to continue.

Step 6. Using the up and down arrows, scroll to Fingerprint and press the M/OK button

Step 7. Using the up and down arrows, choose which finger you wish to enroll and press the M/OK button

Step 7. Have the employee place the chosen finger three times on the sensor as prompted by the device.

Step 10. The device might ask you to “Please try again” if all 3 registration were not similar. If this does happen, simply repeat the process.

Step 11. If registration was successful, the device will display the hands again, with the enrolled finger showing as green.

You can continue to enroll another fingerprint for the same employee, by simply following the same steps starting at Step 8.

Once done, press ESC to exit the menu.